Selfeeder Mechatric MS7: Servo Feed Drilling Unit
High output servo feed type drilling unit is capable of drilling max of φ28 with steel !
High-power model which has a 3.7kW spindle motor and 7,800N thrust.
This unit can perform facing, end-milling and max of 28mm diameter drilling in steel.
Specifications
Feed shaft motor: 2.7 kW AC servo motor
Model Number | No-load rotation speed | Spindle Tip shape (collet chuck) | Chucking capacity | Maximum drilling capacity | Spindle motor | Thrust | Rapid traverse speed | Cutting feed rate | Weight | |||
50Hz | 60Hz | AL | FC | ST | ||||||||
min-1 | ― | mm | mm | kW | N | mm/sec | kg | |||||
MS7-3229 | 2,900 | 3,500 | ER32 | 1.0~20 | 11 | 4 | 3 | 3.7 4P Induc- tion motor | 7,800 | Max.298 | Max. 16.7 | 270 |
MS7-3222 | 2,200 | 2,700 | 13 | 5 | 4 | |||||||
MS7- 3215 | 1,500 | 1,800 | 17 | 7 | 6 | |||||||
MS7-3210 | 1,000 | 1,200 | 20 | 14 | 12 | 2.2 6P Induc- tion motor | ||||||
MS7-3206 | 650 | 800 | 25 | 19 | 16 | |||||||
MS7- 3205 | 500 | 600 | 31 | 24 | 21 | |||||||
MS7-3203 | 340 | 410 | 40 | 32 | 28 |
Notes
1. To select your model, refer to the workpiece configurations, material, cutting properties, diameter of the hole, and rotation speed.(cutting speed)
2. The drilling capacity shown above corresponds to a depth equivalent to the drill diameter times two.
3. The power voltage of the feed controller and main spindle motor is a 3-phase 200V AC±10%, 50/60Hz.
4. In the case of a servo motor with a holding brake (optional), add “B” to the end of the model number.
5. AL*…Aluminium, FC*…Cast Iron, ST*…Steel