STANDRILL series SELFEEDER DUO
Feature
1.Same-day operation is possible！
Leave it to us for renewal of aging tapping drilling machines and after-sales service.
2.Easy programming
4.5 inches small touch panel for manual operation and program setting.
Preloaded programs of machining patterns required for drilling and tapping, easy to program by entering cutting start or end point, spindle speed and so on.
3.Various functions
1.Preset counters ・・・・・・・・・・ 6 digits × 5
2.Capacity of total program records・・・200 records
3.Easy teaching function included
4.Additional options available for customization
ex. Continuous control of fixtures and safety doors Easy and intuitive setting buttons
4.Drilling and tapping by a single unit
High power servo motors for main spindle and feed axis enable very easily to change programs,
from drilling to tapping, or change thread pitch just by a touch panel.
Also high precision tapping is possible by perfect synchronization.
SPEC（ Standard type ）
| Model | SD3-7100B （Dedicated to drilling） |
SD3-1650B | SD3P-1630B | SD3P-1620B | ||
| Spindle speed | min-1 | Max. 10,000 | Max. 5,000 | Max. 3,000 | Max. 2,000 | |
| Spindle torque | N･m | 5,000～10,000min-1 1.4～0.7 |
3,000～5,000min-1 2.4～1.4 3,000min-1 or less 2.4 |
3,000min-1 or less 6.4 |
2,000min-1 or less 9.5 |
|
| Chuck type (Collet chuck) | ER11 | ER25 | ER25 | ER25 | ||
| Chucking capacity | mm | 0.5 - 7.0 | 0.5 - 16.0 | 0.5 - 16.0 | 0.5 - 16.0 | |
| Max. drilling size | AL★ (ADC12) |
mm | 8.5 | 11.0 | 16.0 | 18.0 |
| FC★ (FC200) |
7.0 | 8.5 | 13.0 | 15.0 | ||
| ST★ (S45C) |
6.5 | 7.5 | 11.0 | 13.0 | ||
| Max. tapping size | AL★ (ADC12) |
mm | - | M8 | M12 | M14 |
| ST★ (S45C) |
- | M5 | M8 | M10 | ||
| AC servo motor for spindle |
kW | 0.75 | 0.75 | 2.0 3,000min-1 rated |
2.0 2,000min-1 rated |
|
| AC servo motor for feed |
kW | 0.75 | ||||
| Thrust | N | 2,320 | ||||
| Rapid traverse speed | mm/sec | Max. 200 | ||||
| Weight | ｋg | 32 | 32 | 35 | 36 | |
notes 1. Special specification line-up available, such as high speed type and high torque type.
2. In the above table, upper row is drilling capacity and down row is tapping capacity.
3. The drilling capacity written in the above table is based on values representing
a drilling depth of two times the diameter of the drill.
The tapping capacity is based on using spiral tap or point tap and
a tapping depth is one and half timed the diameter of the tapper.
Dimensions(mm)
